i learn more with each cutting. this is the latest
i learn more with each cutting. this is the latest
What type of bit did you use for that? How did it take to carve?
Looks very nice!
Andrew
the finish tool path was done with an 1/8 of an inch precise tappered bit. the speed was set at 3 inch per second and 7 percent stepover. it took 4 hour and 30 minutes. done in alder, very little fuzzies if any. i forget how long the roughing took... i am sure i did it with a quarter inch bit.
i did a roundover on the profile.
ps thanks, forgot to acknowledge your comment.
Way to go Rick, nice....