Results 1 to 2 of 2

Thread: Installing the Spindle Control Board

  1. 12-15-2009, 06:37 PM #1
    zeke
    zeke is offline Member
    Join Date
    Mar 2008
    Posts
    84

    Default Installing the Spindle Control Board

    Has anyone installed a Spindle Control Board on an HSD / Yaskawa V74X? Anything I should be aware of that the manual or instructions does not cover?
    Reply With Quote Reply With Quote
  2. 12-16-2009, 06:39 AM #2
    kevin's Avatar
    kevin
    kevin is offline Senior Member
    Join Date
    Jul 2009
    Location
    Harbour Grace Newfoundland
    Posts
    771

    Default

    My 19 year old installed using the guide it very easy
    Only hang up is port you might have to manuly enter
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Installing plenum board
    By Ken M in forum Table
    Replies: 4
    Last Post: 12-17-2014, 08:51 PM
  2. Spindle Control Board Question
    By mwpfeifer in forum ShopBot Buddy
    Replies: 10
    Last Post: 03-19-2009, 06:00 PM
  3. Spindle Control Board - Yaskawa
    By jbuell in forum Archives2008
    Replies: 3
    Last Post: 08-21-2008, 10:18 PM
  4. Spindle speed control board
    By dubliner in forum Archives2008
    Replies: 19
    Last Post: 06-22-2008, 09:53 PM
  5. Installing new colombo spindle
    By georgew in forum Archives2005
    Replies: 1
    Last Post: 12-13-2005, 10:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules