Aspire 3D Work for Hire

[FJ Baker]

Greetings All,
I have been plugging away at Aspire doing my best to learn the software in between my 60hr a week job while still trying to spend some time with my five kids, three of whom are all in playing little league. As you can imagine, my mastery of the software is not moving along at a pace that I had hoped for. Having just completed my first paying job on the shopbot, I am in need to hire someone who could do the attached drawing in 3D and write the tool paths as well. The drawing is for a chair back that will be used for nuns at a monastery. If you are interested and can do it really soon, please send me a message with your price and time frame.
Thanks,
John Baker

[paul_z]

Have you tried V Carving it? It might turn out rather nice and take a lot less time to cut it.

You might want to beef up the cross at the top. It looks fragile.

Paul Z

[FJ Baker]

geez,don't everyone jump at once.
Thanks for the advice Paul. Perhaps your right. The other ones that I did for them were done with v carving. Here is a photo.

[Greybarn]

What are you willing to pay for that work?
Regards
Peter

[FJ Baker]

Thank you for the input, it has been taken care of.