Drag Knife

[donek]

I have developed a second model for cutting thicker materials. It can definitely cut material that is 0.150in thick. It should be possible to cut up to 1/4in thick materials as well, but I have not tested that yet. Here are a couple of sample videos showing it in action.

http://youtu.be/P8jbtRTV6uw
http://youtu.be/bMoRUZnvbXw

[donek]

I did a quick test this morning in some 1/4in cardboard. It's actually 0.290in thick material. I just used spray adhesive to laminate two standard layers. It worked fine, but did not seem to want to cut a circle smaller than 2in diameter. Corners would be no problem if programmed correctly.

[geneb]

So what's the asking price for this gadget?

g.

[evan]

Inquiring minds want to know.

[donek]

So what's the asking price for this gadget?

g.

Inquiring minds want to know.

PMs sent to both of you.

[gene]

Hi , send me a pm with a # in it

[donek]

The price for the tool is $189.

[evan]

Thank you.

[knight_toolworks]

well got the knife today and only spent a bit of time with it. but it cut some .03 sintra with no problems and I had a little bit of veneer to try. There will be some tricks on the inlay to get great results like rounding corners and such maybe mirroring the inlay part so the bevel is facing down.

[gundog]

I got mine also is there any programing strategies I should know? How much offset does the blade tip have from center line? I am going to design a small cardboard box and see how it comes out.

Mike