Just for fun ... I clicked the "check for update" button on PartWorks. Vectric said an update was available so I proceeded with the update from 3.503 to 3.504. Anyone have any clue what was updated or changed?
SG
Just for fun ... I clicked the "check for update" button on PartWorks. Vectric said an update was available so I proceeded with the update from 3.503 to 3.504. Anyone have any clue what was updated or changed?
SG
Steve,
Here is how Brian (Vectric) responded to a similar question on the Vectric Forum:
"It only had a couple of minor changes to fix a rare crash which only occurred on XP, and speed up V-Carving in a couple of very specific circumstances."
Tim
Tim
Thanks for the info... Doesn't sound earth shattering but it's good to know Vectric is responding to issues.
SG
The V Carve speed up issue seldom occurred but the patch made a huge difference when it did occur. I had a file that took more than 3 minutes to calculate the toolpath before the patch. After the patch, The toolpath was complete before I could get my finger off the mouse button.
Paul Z
Well Paul... you made me curious. I recalculated some of the V-carve patterns I used on my "Patio Chair" project... Previously I sat and watched the yellow progress bar at the bottom of the page churn back and forth endlessly, now almost immediate!
Thank you Vectric!
SG
How do I get the link for updating part works from version 1.102 to the latest version? Thanks for any help Don Hunter