This is my first design. I wanted to come up with a chair that could be put together without any tools and would take a standard patio cushion. I still have some tolerances to figure out but I appreciate any feedback.
Dan
Member
First Prototype
This is my first design. I wanted to come up with a chair that could be put together without any tools and would take a standard patio cushion. I still have some tolerances to figure out but I appreciate any feedback.
Dan
Senior Member
I like it! Maybe just add a cup holder
Were you able to fit it all on one 4'x8' sheet?
Member
It fits in about two thirds of a sheet. I hope to get three from two sheets.
Last edited by VanIslanddan; 07-12-2010 at 10:51 AM. Reason: spelling
Senior Member
That is very cool but obviously you couldn't use mdf in this application outside right? I like the design, good job
Senior Member
Nice! Care to post the file...
Not mdf but mdo or 4x8x.75 sheets of "recycled plastic" ply...
Gene
Last edited by gc3; 07-12-2010 at 09:22 PM.
Vector Studio 22
Senior Member
Looks good - but is it comfortable?
Senior Member
What actually locks it together?
Member
Yes, I used standard sizes and it is very comfortable for me, I am 5' 11". My son in law is 6' 1" and would like it a bit bigger.Originally Posted by beacon14
Member
Yes, I used a combination of datos, mortices, a C cut, and the angle of the seat and back to lock it all together.
Senior Member
Awesome...looks very comfortable and sturdy...I would be interested if you are selling or sharing the files. Dick
Dick
Aspire 10.5
Posting Permissions
Reply With Quote
