I installed today a fairly simple reception desk I made for two friends of ours, who are opening a new physiotherapy clinic here where I live.

The original place they were going to go with bailed on them, so I made time to get it done (hard since I am very booked up and busy). Its all hard maple veneers and solids (tops, edging, drawers, etc solid with the gables 3/4 veneer) with a dark walnut stain.

WHen I saw their new logo on the building, I suggested to put it on the front of their reception desk. They really liked it.

I scanned the logo into Aspire and cut out the letters, and pocketed the lower ones that are on the triangle and rectangle. Some of the lettering had a little "roughness" due to the way Aspire fit the vectors to the lettering, but I sanded them a little and I think it turned out OK.

The main thing is the customer loved it!

I also cut all the gables (they are curved underneath where its cut away for your legs) and notches, etc on the bot.

AJC