Zeroing Issues

[Cambrian]

Braden,

Even though the table is 48" x 48", the MOVEMENT range on this Buddy is nominally 48" x 24" (the x axis only moves 24"). Therefore you are setting the wrong model. You have a PRS standard BT48 model by the sounds of it. This may be part of the problem. Good luck!

Dave F.

[Braden]

Thank you to everyone for the help! This was a combination of everything suggested here as well as me not knowing what to look for!

The previous owner had a homemade table on the machine and when I put it back on the proximity switches were not getting triggered which led to a few of my issues.

Now that I have my zeros set I need to figure out what to do next lol

Thanks again for all the help