I was wondering if anyone has ever experienced this when running a CR or table resurfacing?
After finishing the cut my Z returns home then plunges (fast) to zero while the router is still running before turning off the router. It's quite unnerving watching a rapid plunge touch the surface of a freshly surfaced table. I've looked through the file & can't see why it's doing this.
Here's the code in my surfacing file:
---------------------------------------
IF %(25)=1 THEN GOTO UNIT_ERROR 'Check to see software is set to inches
SA 'Set program to absolute coordinate mode
VC,2.75,,,,,15
JZ,1.00 'Jog Z axis to safe height
JA,2.00 'Jog A axis to safe height
J3,0,0,1 'Jog to start position
SO,1,1 'Turn on router 1
PAUSE 2 'Give router time to reach cutting rpm
MZ,0
CR,97,49,T,1,4,0,1,2,1
JZ,1
SO,1,0 'Turn off router 1
END
'----------------------------------------------------------------
UNIT_ERROR:
C#,91 'Run file explaining unit error
END