Ok, I've got everything all put together and I've used the CR command to cut down an oversized sheet of 3/4" MDF down to 96x48 to use as test victim/spoilboard.

Knowing I had issues before I started cutting, I figured if this was messed up I could just keep cutting it down until it was square.


As measured diagonally I get 107-1/8" one way and 107-3/8" the other. This makes me think I may have a trapezoid on my hands, right?

I measured the length of the panel in multiple places and get 96" every time. I measured the short width in multiple places and I get 48" every time.

From what I've read from the many discussions here, this should definately NOT be the case. If nothing else I should have a detectable trapezoid on my hands and I don't.

Have I made some silly mistake in measuring or am I just looking a gift horse in the mouth? I've measured the diagonals four times, twice from either end of the table. Came out the same each time. I'm totally confused.

Oh great learned ShopBotters, help!


tnx!

g.