Results 1 to 5 of 5

Thread: Toolpath Training Video

  1. #1
    Join Date
    Dec 2010
    Location
    Mooresville, NC
    Posts
    70

    Default Toolpath Training Video

    Has anyone else downloaded TJ's video and watched it past the 22 minute mark? For some reason the video goes blank for me after 22 minutes and the software (windows media and also VLC viewer) shuts down. I was able to download the full 235 meg and the video shows it should be 2 hours long, but I cannot get it to play past 22 minutes. Any help would be appreciated.

  2. #2
    frank Guest

    Default

    Hi Rick,

    I just downloaded the video and the whole thing plays, so it sounds like your download is corrupt. I would try downloading it again and use a download manager in case the download is interrupted you are able to restart where you left off.

  3. #3
    Join Date
    Dec 2010
    Location
    Mooresville, NC
    Posts
    70

    Default

    Thanks for the reply - I will attempt a new download.

  4. #4
    Join Date
    Jul 2008
    Posts
    300

    Default

    May i ask where the video is posted at?
    thank you
    frank

  5. #5
    frank Guest

Similar Threads

  1. SB Link Training Video User Input
    By Gary Campbell in forum Cabinetry and eCabinet/ShopBot Link
    Replies: 21
    Last Post: 06-05-2022, 11:54 AM
  2. ecabs link video training?
    By jTr in forum Cabinetry and eCabinet/ShopBot Link
    Replies: 7
    Last Post: 11-25-2012, 01:59 PM
  3. Video streaming of Jamboree training today
    By bill.young in forum ShopBotter Message Board
    Replies: 1
    Last Post: 04-22-2010, 09:59 AM
  4. Replies: 0
    Last Post: 02-22-2010, 12:35 PM
  5. Artcam 6 Training video CD
    By zeykr in forum Archives 2004
    Replies: 1
    Last Post: 07-08-2004, 03:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •