The site on page one post one on this thread. http://cncmilitaryemblems.com/
The site on page one post one on this thread. http://cncmilitaryemblems.com/
It has been a while since i added to this post. But here are some that i have done in recent months
Cowboy,
This is state of the art carving. I'm proud for you.
Joe
Thanks Joe. That was one of the prettiest pieces of black walnut used in the Tun Tavern that i have had in a long time. The panel is one those free 3-d components offered by Vectric when you do an upgrade. That was the first one that i used and i like it. It was 33 inches long by 18 inches tall and will be mounted in a man-cave/bar.
BEAUTIFUL cuts,design, and finish Rick!!!
Ya keep getting better
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Very nice! Were you contracted to do those? Very timely on the Sheriff officers!
Tom Bachman,
Drafting/Woodworking Instructor RETIRED!
Lakin, Kansas
2001 PRT4896
https://i.imgur.com/xWEFfDk.jpg
The marine mantle piece went to a benefit founded by some friends of mine who lost their marine son in some shit hole in iraq.
I have done several memorial plaques for Police who were killed in the line of duty but i cant keep up so i dont do all of them.
The Tun Tavern one i did get money for but trust me i could not make a living out of what i got.
PM sent, thanks for the response.
Latest plaque. It is not through yet. Still needs stain for the letters and two final seal coats.