Importing/Tracing Bitmaps and DXFs

[TJ]

Importing/Tracing Bitmaps and DXFs Wednesday February 6th at 1:00pm eastern
Hello everyone,
Tomorrows two hour training will cover Importing/Tracing Bitmaps and DXFs. This is very helpful for drawing in other software and importing into PartWorks. This will also be very useful for bringing in .jpeg, bitmap, etc. and tracing them to the exact logo or image.

Upcoming training will cover machine maintenance on February 20th. This will have me with a camera on the physical machine.

Remember all of these sessions are recorded so if you cannot make it you can watch at a later time.

I always welcome your training ideas for future sessions.

Please send me any suggestions that you have so I can try to make ShopBot training for 2013 the best it can be for you!!!
Thanks, TJ


1. Please join my meeting.
https://global.gotomeeting.com/join/975535133

2. Use your microphone and speakers (VoIP) - a headset is recommended.
Or, call in using your telephone.

Dial +1 (213) 493-0014
Access Code: 975-535-133
Audio PIN: Shown after joining the meeting

Meeting ID: 975-535-133

GoToMeeting®
Online Meetings Made Easy®

[jerryk]

TJ
I missed this class and would very much like to view. Could you please indicate the name and location of the download file where I can view.
Thanks
Jerry

[shilala]

Try this, Gerald.
That link is from way down at the bottom of Shopbot's Training Classes page.
I don't think the webinars get updated very often, but it's worth a look.

[jerryk]

Thanks Scott, I had looked there, but as you say, I don't think the page has been updated yet. At least I can't find it.
Jerry

[TJ]

I am still waiting for our webmaster to update that page. Until then I have put this on a YouTube to watch.

http://www.youtube.com/watch?v=h08RdsuezoM

Enjoy!!! TJ

[TJ]

http://www.shopbottools.com/videos/I...ingBitmaps.wmv