Hi Guys,
I know it's been quite a while since I started this thread. For whatever reason I used to get email notifying me when new replies hit my post and on this one I didn't. Normally getting such quick replies from everyone on here is a standard and I found it odd that I hadn't seen anything. Being so busy I completely forgot to follow up and read on here.
It would be AWESOME if someone developed a good iPhone/android app for our TalkShopBot forum as most of the time when I'm digging through here for info I'm at my shop with limited internet access usually via my smartphone and it never remembers my login info ANYWAYS.... Laser scanner. Sounds like a good place to start.
I did tell the customer it would most likely be very pricey. I think the piece is somewhere in the 15/16th are of thickness but I'll double check when I go back to my shop for my second shift tonight and post again with some details. Personally think from a finishing standpoint that it would be harder to fix it then to just make a whole new piece. I'll also PM Brady to see what his thoughts are unless you all think I should start somewhere different then that.
Anyway, it was a nice surprise to see this thread with all the replies today. I actually logged on to start another thread with some questions about cutting laminate covered sheets of particle board for some cabinets and saw this thread sitting here still. So I apologize for keeping everyone hanging on this one. I have been just swamped with boring laborus cabinet work lately and haven't had much time to do any fun CNC work. Hope everyone is doing well. Cheers.
Nate Sirek
Operations Manager;
Shop Fabrication Manager
House Partners Inc.
West Saint Paul, MN
Shopbot 48 x 96 PRT Alpha
220v 18000 RPM HSD Spindle
4 Zone Vacuum Table, 7hp Spencer Re-Gen Blower
Cabinet Parts Pro
10 Years Experience in a cabinet and counter top fabrication shop. CNC Newbie.