This must be the day for the XY Routine questions.
I have a PRTAlpha and I'm trying to modify the set_prox.sbp file for some new prox switches like the PRS uses. I go into the file and make my changes to the Check_Switch_Status section. I save the file then exit the file then go back in to make sure the change are there and they are. I run Tools/Shopbot Setup and select the "Make it easy on me", it hits the limit switch and errors out. I go back and look at the setup_prox.sbp and it defaults back to the old settings. Does anybody know if it is copying the file from another location and copying it over each time. I can't figure out were the file may be getting copied from.
I modified the XYzero.sbp and the change work great. The XY zero like they should.
Andy B.