Table sides

[steve]

OK it's here , started putting the table together to day. I have a 12"Z , so two sets of sides , my question is , should the two sides , one sitting on top of the other , be connected? They are both fastened at the ends of course , the lower side has the cross beams attached and the top side has only the X-rails to resist any flex. Seems to me they should be connected. Maybe I missed something?

Stephen

[steve4460]

Hi Stephen
There is 2 plates with 8 holes in them that get put in the middle of the 2 aluminum extrutions
Check your manual or go here http://www.shopbottools.com/files/do...ateInstall.pdf
Good luck and happy botting
Stephan

[steve]

Thanks Stephan , that information is not in my manual.