Folks, could use some help here with wiring. Would appreciate advice on if I have this set up right before I turn my shopbot into an expensive smoke machine.

I'm wiring the outlet for the router on the carriage and the power box to the wall outlet (that an electrician put in).

Here's how I have them wired:

Outlet ontop of Y carriage:
shopbot black to brass screw
shopbot white to silver screw
shopbot green to green screw on end of outlet
shopbot red to "Dead Head w/ cap?"

Wall outlet for shopbot power:
shopbot pink - wall outlet pink
shopbot beige - wall outlet white
shopbot black - wall outlet green
shopbot green - wall outlet bare brass
wire information for outlet: 10-3G type NM-B 600V E10816B

Suggestions?

Thanks,
Joe Winslow, www.regimentalsigns.com
cell 469 363 0651