Stop Button On?

[nat_wheatley]

FWIW I'm remembering that after reloading firmware I had to turn the control software off then on again to get rid of the error.

[wberminio]

Frank
Disconnected stop in control box -Nothing same message
Nate
Did that -same
Still waiting for tech support

[wberminio]

When I hit reset button there is no click in box

[supertigre]

VN

Switch#4 STOP Type

you may need to change it to;

0 - Nrm closed stop

or

1 - Nrm open stop

Depending on the type of stop button you have.

YMMV

[wberminio]

Hi Guy
Thanks
Tried that also .Nothing Same issuse

[supertigre]

If you have two stop buttons then;

If they are normally open you have to wire them in parallel so that closing either switch will close the circuit and trigger the stop.

If they are normally closed you have to wire them in series so that opening either switch will break the circuit and trigger the stop.

Stay safe and have fun out there.

If you have a VOM you can check if the switches are normally open or closed and if your stop button(s) is working at all.

[wberminio]

Everything was working fine when I closed down yesterday.
Nothing was touched
Started up today and for 4-5 hours same issue

[supertigre]

It doesn't happen very often but maybe your stop button broke and is now stuck in the "off" position. This can be checked with a continuity tester / VOM. A broken wire on a normally closed switch would also act this way.

[srwtlc]

When I hit reset button there is no click in box

Sounds like one of the contactors in the box may be stuck. Try giving it a few love taps to maybe get it working for the time being.

[wberminio]

Scott
I owe you a beer!!!!
Next time you're in NY look me up!

My grandfather used to hit his TV to get it to work
Who would of guessed!
Thanks
Erminio