Thanks Dick!
Same little $4 Kyocera 60degree engraving as when you were here. Did try an Onsrud .25 engraving bit and My Vortex 2F 60degree again, trying to eliminate a bit change, but had tearout where Fluting toolpaths met. Seems a new sharp bit with low mileage and a second "speed pass" eliminated both tearout AND sanding..looks almost burnished in person. Edges on cutout are only thing that needs sanding to soften.
Getting boring though...inlays and Celtics and Tin now this design is done
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine