This was not really supposed to be a project but an experiment and I posted a question about my V-carve depth step problems on the Vectric forum (actually I found the tip grind of the cheap bit is cause of the problem).

But somebody asked to publish the Vcarve file, which I did and, since I am hanging out here quite often lately I thought some of you guys might be interested, too. Please use as you see fit.

This is a Vcarve of a fractal pattern that I created in Ultrafractal 5. My sample was for a 12"x16"x1.5" board but the published file is for a 12"x16"x0.75" board. Nothing really useful but something to play with.