Thanks G. Just looked at it and things look a little battered (like the first "O" in Shopbot). Is that an effect of the fractal program? or a low res .jpg? Just curious. Will run by Dianne at Shopbot(Or maybe Nancy will pop in) to make sure using their logo doesn't bring their lawyer down on me.
scott P.
2013 Desktop/spindle/VCP 12.0*
Maine
They have made the logo freely available in the past and i thought it was intigrated into the control software to cut as a first cut sample
look in the Command Consolse/C1/Shopbot Logo >>>Custom Cut Demo
So i don't think it is a issue.
Words of Wisdom:
“Words that sink into your ears are whispered…… not yelled”
“The biggest trouble maker you’ll probably ever have to deal with, watches you from the mirror every morn’n”
“The only difference between a rut and a grave is the depth”
-----------
Just remember...when it's time for the hearse to pull up..there's no luggage rack on top!
-----------
The beauty of the Second Amendment is that it will not be needed until they try to take it...Thomas Jefferson
Thanks Jack, Sun will be up soon, you better book
scott P.
2013 Desktop/spindle/VCP 12.0*
Maine
It's ok i'm in the basement with the shades drawn over the windows with my "bed" lid propped open.
Words of Wisdom:
“Words that sink into your ears are whispered…… not yelled”
“The biggest trouble maker you’ll probably ever have to deal with, watches you from the mirror every morn’n”
“The only difference between a rut and a grave is the depth”
-----------
Just remember...when it's time for the hearse to pull up..there's no luggage rack on top!
-----------
The beauty of the Second Amendment is that it will not be needed until they try to take it...Thomas Jefferson
Yes in a way because these fractals are self-replicating in ever smaller identical patterns. In this case a small image just happens to overlay a bigger one. In UF5 you can change the scaling from very small stand-alone images up to large fully overlapping ones that you don't recognize the original anymore. This is somewhere in between.
Another fractal design....
Came out quite nice, carved in hard maple but I have to reconsider the use of oil stain for highlighting of the cut surfaces. Although the wood was laquered before carving there is some significant and visible bleeding that I can not sand away.
This is a test carve for a larger one that I want to do for a table surface sometimes. Either filled in with Epoxy or maybe as an inlay (the latter would be difficult, though).
Now that one has some real potential.
"Once a person moves away from the computer and CNC some of the most important work begins." ~Joe Crumley