Results 1 to 5 of 5

Thread: Anyone in or close to IL with an indexer?

  1. #1
    Join Date
    Apr 2001
    Location
    South Elgin, IL
    Posts
    455

    Default Anyone in or close to IL with an indexer?

    I have an idea that I wanted to get done on an indexer and to keep shipping cost to a minimum, ideally I'm looking for someone in Illinois or close to IL. The finished part will be about 3 inch diameter by about 12 inches long.

    If I figure out how to create the file in Aspire, then I would supply it in ver 3.5 format or I could export it as a design file before it gets wrapped or rotated or however would be best.

    Basically I'll need a repeating design engraved about 1/4 inch deep.

  2. #2
    Join Date
    Oct 2009
    Location
    Larrabee IA
    Posts
    171

    Default

    Mayo I'm in N.W Iowa if that helps Thanks Mark Stief

  3. #3
    Join Date
    Apr 2001
    Location
    South Elgin, IL
    Posts
    455

    Default

    Hi Mark

    Thanks for responding
    I sent you an email...

  4. #4
    Join Date
    Jun 2007
    Location
    Sadieville, Kentucky
    Posts
    153

    Default

    Greetings, Mayo

    I am in Central Kentucky if that works for you. I don't have Aspire, I use ArtCAM Pro.

    Kind regards,

    Jim van Vegten

  5. #5
    Join Date
    Apr 2001
    Location
    South Elgin, IL
    Posts
    455

    Default

    Jim,
    you have a message.

    Thanks for the reply.

Similar Threads

  1. Tool Close Out
    By garyb in forum Product/Supplier List and Requests
    Replies: 2
    Last Post: 06-02-2016, 07:56 AM
  2. close to checkering?
    By scottp55 in forum Project Ideas
    Replies: 4
    Last Post: 04-28-2014, 09:05 AM
  3. Its getting close for the iPad!
    By Bob Eustace in forum ShopBotter Message Board
    Replies: 4
    Last Post: 06-29-2013, 09:20 AM
  4. How close is close enough
    By crash5050 in forum Table
    Replies: 5
    Last Post: 11-13-2012, 11:17 PM
  5. Close yet again
    By carlhopkins in forum Folder 2012
    Replies: 0
    Last Post: 08-14-2012, 04:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •