Results 1 to 4 of 4

Thread: unable to control rpm for spindle

  1. #1
    Join Date
    Mar 2014
    Location
    Monroe, NC
    Posts
    12

    Default unable to control rpm for spindle

    PRS Alpha 48 x 48, 10 days old. This is an initial startup. Brand new to this. The cars move fine, the spindle comes on and runs, but when I try to set the rpm values for the spindle warm up, it gives me a "runtime error-13 type mismatched" box. Tried updating to the newest version of software but get the same thing. Any suggestions?

  2. #2
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,845

    Default

    Joseph, check out this thread. http://www.talkshopbot.com/forum/showthread.php?t=17807

    Once done, you'll need to click on 'rpm' in the spindle control window and enter the proper values for your setup in the fill in sheet that comes up.
    Scott




  3. #3
    Join Date
    Sep 2009
    Location
    Surrey, UK
    Posts
    1,271

  4. #4
    Join Date
    Feb 2015
    Location
    Union, NJ
    Posts
    16

    Default

    Thank you soo very much for saving me so much time....

Similar Threads

  1. Unable to change spindle speed
    By dbrannen in forum VCarvePro and PhotoVCarve
    Replies: 5
    Last Post: 06-21-2016, 11:00 AM
  2. Spindle control problem
    By dconroy in forum ShopBotter Message Board
    Replies: 5
    Last Post: 06-30-2015, 10:16 AM
  3. Spindle control
    By tlempicke in forum Techniques for Cutting, Drilling, Machining
    Replies: 2
    Last Post: 10-29-2011, 11:00 AM
  4. Spindle control from SB3
    By dubliner in forum Archives2008
    Replies: 30
    Last Post: 01-29-2008, 09:47 PM
  5. Spindle Control
    By john_l in forum Archives2007
    Replies: 10
    Last Post: 09-26-2007, 02:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •