Results 1 to 4 of 4

Thread: unable to control rpm for spindle

  1. #1
    Join Date
    Mar 2014
    Monroe, NC

    Default unable to control rpm for spindle

    PRS Alpha 48 x 48, 10 days old. This is an initial startup. Brand new to this. The cars move fine, the spindle comes on and runs, but when I try to set the rpm values for the spindle warm up, it gives me a "runtime error-13 type mismatched" box. Tried updating to the newest version of software but get the same thing. Any suggestions?

  2. #2
    Join Date
    Dec 2000
    Thorp, WI


    Joseph, check out this thread.

    Once done, you'll need to click on 'rpm' in the spindle control window and enter the proper values for your setup in the fill in sheet that comes up.

    "He who would trade liberty for some temporary security, deserves neither liberty nor security" - Benjamin Franklin
    "Make yourself sheep and the wolves will eat you" - Benjamin Franklin
    "Symbolism is for the symbol minded" - George Carlin

  3. #3
    Join Date
    Sep 2009
    Surrey, UK

  4. #4
    Join Date
    Feb 2015
    Union, NJ


    Thank you soo very much for saving me so much time....

Similar Threads

  1. Unable to change spindle speed
    By dbrannen in forum VCarvePro and PhotoVCarve
    Replies: 5
    Last Post: 06-21-2016, 11:00 AM
  2. Spindle control problem
    By dconroy in forum ShopBotter Message Board
    Replies: 5
    Last Post: 06-30-2015, 10:16 AM
  3. Spindle control
    By tlempicke in forum Techniques for Cutting, Drilling, Machining
    Replies: 2
    Last Post: 10-29-2011, 11:00 AM
  4. Spindle control from SB3
    By dubliner in forum Archives2008
    Replies: 30
    Last Post: 01-29-2008, 09:47 PM
  5. Spindle Control
    By john_l in forum Archives2007
    Replies: 10
    Last Post: 09-26-2007, 02:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts