I have a newer PRS Standard (3.8.14) with spindle running Vectric Aspire (4.510). First time this has happened.
After loading a cut file that worked fine yesterday (created in Aspire and saved with same post-processor I've been using), the gantry moves but spindle stays off. The interlock key is still on. The spindle warm-up routine works fine - spindle spins. I've restarted, rebooted.
I attached a screen shot of the messages - something about "check to see software is set to standard" and "Set program to absolute coordinate mode"
Obviously, I've hit a button, moved something, deleted something. Any ideas? Thanks in advance.
Chris