Its rather incredible how this craftsman can assemble such a complex piece of kit in just 11 minutes - and hes not following a manual!
http://youtu.be/Xuc8sVERy6Q
Its rather incredible how this craftsman can assemble such a complex piece of kit in just 11 minutes - and hes not following a manual!
http://youtu.be/Xuc8sVERy6Q
Buddy BT48 with 6' power stick
2.2 HSD Spindle
Aspire 9.5
6" ShopBot Indexer
Thanks Bob, I was wondering where the CNC came in. Fascinating and like that last little "touch"
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Next we will no doubt see McDonalds putting their logo on the top of their coffees using a CNC! Seriously though it is amazing how far we have progressed in just 50 years and all the technology that has gone into that motor and the thing turns by hand first pop! I could never remember all the steps that technie has to follow and I only saw him look at one bit of paper for a second. Amazing!
Buddy BT48 with 6' power stick
2.2 HSD Spindle
Aspire 9.5
6" ShopBot Indexer
Really cool. Assembly under perfect conditions. He didn't seem too concern about the rings spinning. Ive always wondered if the whole "clocking the rings" thing really helps anything at all beyond the first few minutes the engine runs.