Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Beta Tester Results Replys Please

  1. #21
    Join Date
    Dec 2007
    Location
    David Marcotte Svc LLC, Cocoa Fl.
    Posts
    544

    Default

    Keith, I am still using the 1 2+2 3/8 bit you sent to me. I beleive this is a compression bit?
    I have cut well over 150 sheets of 3/4 pre finished birch ply with dadoes for cabinetry. I also use the same bit for door board (5/8 mdf with liner on one side) It cuts very clean. Recently I have cut about 200 brackets from maple lumber (3/4) each one was about 1.5 - 2 sq. ft. of cut.
    Then today I am cutting plywood again and no signs of any wear at all.
    I cut plywood at 5 IPS. I need to order 2 of the 1/4" and 2 of the 3/8 bits as I seem to be geting busy.
    These are by far the best bit I have used in my short career as a cnc owner. (2007)

    Thank you, David

  2. #22
    Join Date
    Dec 2007
    Location
    David Marcotte Svc LLC, Cocoa Fl.
    Posts
    544

    Default

    Keith, I wanted to thank you for the prompt delivery on my bits.
    I am sending a couple to my brother in Maine. I am actually still having good cuts fro the sample you sent me.
    I purchased one for my brother and an extra 2 for myself. I used the 1/4" bit with single flute for cutting soft maple. I needed to have a tight radius other wise I would use the 3/8 bit.
    It performed excellent, very good edge quality.
    The delivery was there the next day and the shipping was the less than ground via UPS

    you are my new bit guy for sure.

Similar Threads

  1. Search results
    By sbd1 in forum About this Forum
    Replies: 9
    Last Post: 06-08-2012, 10:45 AM
  2. Test Results
    By Gary Campbell in forum Folder 2010
    Replies: 15
    Last Post: 12-15-2010, 09:00 PM
  3. Results Required.
    By penman in forum ShopBotter Message Board
    Replies: 4
    Last Post: 11-20-2009, 03:39 PM
  4. 3D carving results and survey.
    By david_gardner in forum ShopBotter Message Board
    Replies: 25
    Last Post: 03-11-2009, 10:02 AM
  5. Not impressed with results!
    By myxpykalix in forum Archives2006
    Replies: 3
    Last Post: 10-24-2006, 10:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •