Is there a way to run a CRV3D file on a shopbot?
Is there a way to run a CRV3D file on a shopbot?
2 wrongs don't make a right
But 2 Wrights makes a Airplane
Kevin Matney
Visit www.Matneymodels.com
734 - 848 - 8195
ONE FLAG, ONE LANGUAGE, ONE NATION UNDER GOD
As with any file created in any program it needs to be turned into a toolpath. You can only run toolpaths on the shopbot control software.
If you have a file that needs to be made into a toolpath maybe someone with that program could do that for you.
Words of Wisdom:
“Words that sink into your ears are whispered…… not yelled”
“The biggest trouble maker you’ll probably ever have to deal with, watches you from the mirror every morn’n”
“The only difference between a rut and a grave is the depth”
-----------
Just remember...when it's time for the hearse to pull up..there's no luggage rack on top!
-----------
The beauty of the Second Amendment is that it will not be needed until they try to take it...Thomas Jefferson
A CRV3D file is a Vectric Aspire file. You would need to load it into Aspire and save the toolpaths using the ShopBot Post Processor.
The answers to a lot of questions can be found at http://www.shopbottools.com/ShopBotDocs/ or http://support.vectric.com/
I done not have Vcarve Pro. All I have is what ShotBot give you
2 wrongs don't make a right
But 2 Wrights makes a Airplane
Kevin Matney
Visit www.Matneymodels.com
734 - 848 - 8195
ONE FLAG, ONE LANGUAGE, ONE NATION UNDER GOD
Kevin, what is the file for? If it contains any copyrighted relief models or other stuff, you're out of luck. If it doesn't, then one of us with Aspire could help you out.
Scott