I am running a tool path set in mm. (machine is still in Inches)
For some reason it wants to kick up the error "TOOL STOP BUTTON IS ON" and then goes in to a fault on inp 4. I have checked line 9 and find nothing remarkable about it. "LN:9 1052.99, 375.00, 92.00"
Needless to say the stop button is not on.
When I set the top of material routine up it says it will convert the results to mm. Is it possible that the conversion is mucking it up? I am stuck, I have rewritten the tool path several times and still wind up with the same result.
Mark