Controller upgrad for 2007 PRT Alpha 96?

[geneb]

You're welcome! Good luck. It's an easy upgrade.

g.

[aschutsky]

You're welcome! Good luck. It's an easy upgrade.

g.

Gene - Thanks very much again for posting this. I was able to order my card this morning. Can't wait to get on the latest version.

[geneb]

Mine is due on Wednesday.

g.

[aschutsky]

Gene - you up and running yet with the new board? Install was easier than I thought. I'm up and connected although I must have knocked one of the prox switch wires out, have to fix that in the morning.

[geneb]

I haven't had a chance to get it done. I only cut parts on Saturdays and I've got two more sheets of parts to cut - I don't want to fiddle with the machine until I've got everything for the current project done. (I'm running a "Wharthog" for myself and a friend - check it out: http://forums.eagle.ru/showthread.php?t=78417&page=6)

I plan on moving the control box and I'll get the controller upgrade done when I do that task.

g.

[aschutsky]

I haven't had a chance to get it done. I only cut parts on Saturdays and I've got two more sheets of parts to cut - I don't want to fiddle with the machine until I've got everything for the current project done. (I'm running a "Wharthog" for myself and a friend - check it out: http://forums.eagle.ru/showthread.php?t=78417&page=6)

I plan on moving the control box and I'll get the controller upgrade done when I do that task.

g.

Cool project! I don't blame you for not wanting to mess with it in the middle of the project, I did the same. You should be pleased with the outcome though, it's very straightforward.