Setting up a PRSAlpha 48X48. The YZ car slides all the way to the left and the car hits the side of the gantry. Obviously this is not correct. The factory was supposed to install the bolts and end stops, but it does not appear they are in the correct position.

Can someone send me the correct positions?

I have the bolts set so that it triggers the prox switch when the yz car is about 2 inches from the gantry and the end stops so the yz car stops 1 inch from the gantry.

Is this an okay setup?

First-time, so I have no experience. Thanks for the help!

Dave