Results 1 to 2 of 2

Thread: Y axis end stops and prox switches

  1. #1
    Join Date
    May 2014
    Location
    Dallas TX
    Posts
    2

    Default Y axis end stops and prox switches

    Setting up a PRSAlpha 48X48. The YZ car slides all the way to the left and the car hits the side of the gantry. Obviously this is not correct. The factory was supposed to install the bolts and end stops, but it does not appear they are in the correct position.

    Can someone send me the correct positions?

    I have the bolts set so that it triggers the prox switch when the yz car is about 2 inches from the gantry and the end stops so the yz car stops 1 inch from the gantry.

    Is this an okay setup?

    First-time, so I have no experience. Thanks for the help!

    Dave

  2. #2
    Join Date
    Jan 2004
    Location
    iBILD Solutions - Southern NJ
    Posts
    7,986

    Default

    The bolts/targets are NOT factory calibrated. Move them manually so that they trigger just before the mechanical stop. Be careful not to poke the barrel of the sensor out too far or it'll get shaved off.

    To gain extra travel in the -Y direction, remove the bolt and nut closest to the gantry end plate, and slide it all the way back against the end plate. Tighten it up.

    -B
    High Definition 3D Laser Scanning Services - Advanced ShopBot CNC Training and Consultation - Vectric Custom Video Training IBILD.com

Similar Threads

  1. Prox Switches
    By jimmya in forum Accessories Setup
    Replies: 18
    Last Post: 01-24-2010, 07:26 PM
  2. Y axis prox switch and end stops
    By gg_haskell in forum Gantry and Y-car
    Replies: 1
    Last Post: 11-03-2008, 08:46 AM
  3. Touchy prox switches
    By byoc in forum Archives2007
    Replies: 1
    Last Post: 12-09-2007, 07:50 PM
  4. What Prox Switches does the Shopbot Use
    By flyguy in forum Archives2007
    Replies: 4
    Last Post: 03-15-2007, 12:55 PM
  5. Replies: 12
    Last Post: 01-20-2005, 11:51 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •