Safe Z

[wegner81]

My safe Z has been 1 "
today went to run a tool path and it is at .25 on my partworks screen
how do I change that back
got lucky bit cut into my hold down jig but didn't break it

[scottp55]

Kevin, sorry if I'm misunderstanding. You would have to go back into Partworks and on the toolpath side, go into "material set-up" and change the safe Z settings to what you want, Re-calculate all toolpaths, and resave them in the same folder same names and then resave the whole .crv.
If SB3, then VC and change Safe-Z there.
I'd make sure first though that you had referenced Z from the same spot as you called out in the file though(Not that I'VE ever done that ).
Sorry if that wasn't what you were asking.

[wegner81]

Scott
In my material set up I do not have the option to change safe z height just material thickness

[wegner81]

Scott
I think I found it
Thanks for the reply
I think there are Gremlins changing my settings !!!

[bleeth]

Note there are 2 settings for z. One is the safe z and the other is the home z. You have to make sure that the safe z and the home z are good for what you want to do.

[adrianm]

Scott
I think there are Gremlins changing my settings !!!

You may have opened a file with different values which will be the ones used the next time you start a new job.