Shop cold- Reddy heater problems

[jerry_stanek]

If you have a TSC or Rural King they should have them

[myxpykalix]

I got a new glow plug, nozzle, air filter, and replaced, still not igniting because no fuel is coming out of the nozzle. There are 2 fuel lines leading to the nozzle but i can't get to the fuel filter. Does anyone have a schematic or know how to get to the fuel filter? I don't want to just pull on those lines without knowing how to get to the fuel filter.

[Ger21]

Google "reddy heater schematic"

[myxpykalix]

I may have found a possible reason for a problem. Look at this pic, there are two rubber hoses leading from the nozzle. One goes to the air filter at the back of the unit and the other goes down (presumably) to the tank for the fuel.

Notice where the red arrow is in the pic and that hose had a large hole in it like from rubbing up against something. That was for the air line. So i need to replace that.

Now look at the white arrow. My assumption is that, that is the fuel filter although the replacement doesn't look like that. I assume i need to take that out insert the new filter there correct?

btw...if you have the lid off will it still start? Or is there some type of safety device where it won't start without putting the lid back on?

Gerry...did that, didn't find my model
EDIT....it might help if i spell SKEEMATIC correctly for searching...thanks!

[myxpykalix]

SUCCESS

Thanks to those who helped me...i appreciate it!

edit...**** don't know why it won't post straight! (censoring my post?)