Not sure what machines the reset button is on. I have a buddy 32, prs standard.
I have cut several tool paths since i have noticed a problem. but most were successfully after i executed the SO 1 command.
I need to do a large 3-d cutting starting today. I will start the roughing today after rebooting everything. I will report back what i see.
FYI i never trusted 3.8 control software and i am still running 3.6. can anyone say that the latest version of 3.8 is working properly?
Not sure why i did this but i did do it right before my problem. I moved my post processor in and out of different folders in an effort to only have the shopbot arcs inch PP in aspire. i have now moved all pp back into PostP folder. It does not make sense but could i have damaged the PP during these moves?