Originally Posted by
scottp55
Nice Job Dana!
What size bit did you go with? That's the problem with going "Small".....TRYING to get the detail Dan gets going "Large".
Never mind my machine can't hack the Size----It's owner couldn't hack the Time!
LOVE looking at this stuff
scott
I carved it with a 1/16 ballnose bit and then went over the bottom half with a 1/32 ballnose for better detail, the 1/16 carve took 2 1/2 hours( whole model) and the 1/32 bit took 3 hours (for half the model).
The estimated time was less than half that. So I need to play with that some.
yellow machine,
Stinger 1 w/PC Router