Playing with Todd Bailey's "Celtic Circle" design today with VCP8 for practice, and to have something to show Dad tomorrow.
http://www.4m3d.com/whatsnew/tag/celtic
One on left had roughing pass with the same .0625"downcut from Drillman1 as I used in buttonholes and to do a vector boundary. Finish pass was with Drillmans Kyocera .125 45degree engraving.
One on right was no roughing/no vector boundary/no buttonholes/same 45 bit.
NICE with VCP8 to manipulate a 3D toolpath IN VCP for proto'ing
Still a 3D newbie and feeling it out. Walnut blank cut at Bloodwood speeds.
No sanding yet, But ran twice for Fuzzies.
MY idea of a nice 3D!! 16:03
Thanks Todd!!!