Results 1 to 2 of 2

Thread: Shopbot PRT output 4

  1. #1
    Join Date
    May 2015
    Location
    Waxhaw NC
    Posts
    8

    Default Shopbot PRT output 4

    Hi just got my shopbot working after buying a used one with a faulty driver card. I noticed that output 4 goes active when I run the positioning dialog (XY and Z moves) and any program. How do I switch this off and have output 4 and output 3 active only when I run a program and both off at program end?
    Last edited by Andrew Ward; 05-17-2015 at 09:52 PM.

  2. #2
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,845

    Default

    Output 4 is the warning flash that you see in the position window (could also be tied to an external warning light if desired) and depending on if you have something set up for output 3, you may have it set wrong in VI (Values input output switch modes). Default is '0'
    Scott




Similar Threads

  1. output problems
    By Tim L in forum ShopBotter Message Board
    Replies: 0
    Last Post: 11-04-2012, 01:21 PM
  2. PRT TTL Output Values
    By pat_wardell in forum Variations & Modifications of ShopBots
    Replies: 16
    Last Post: 04-14-2010, 08:37 PM
  3. When to use arc .sbp output?
    By blackhawk in forum VCarvePro and PhotoVCarve
    Replies: 6
    Last Post: 07-25-2008, 03:48 PM
  4. 3D Studio Max output for ShopBot
    By shanhew@polaris.net in forum Archives - thru 2002
    Replies: 19
    Last Post: 05-11-2001, 01:31 PM
  5. Shopbot Output driver
    By sascha900@aol.com in forum Archives thru 2002
    Replies: 18
    Last Post: 05-10-2001, 01:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •