This ShopBot has been very well taken care of and works great. It’s a very low hour and lightly used machine. If you have the power needed, you can start cutting immediately!
• Choice of Vacuum Hold-down or T-Rail
• Dual z-axis
• 3 hp Colombo Spindle: 220v Single-phase Spindle with Delta VFD
• 3.25 hp Porter Cable router
• Woodtek dust collector
• Extra Collets, Bits, and many extras etc.
I am located in Pinehurst, NC and asking $9,000.
IMG_0492.JPG IMG_0491.JPG IMG_0496.JPG IMG_0498.JPG IMG_0497.JPG