Has anyone figured out how to make a 3 axis Z zero plate? (I would love a pre-made one but at $250 USD it would cost me about $430 Canadian with exchange, fees, taxes.)
Thanks
Has anyone figured out how to make a 3 axis Z zero plate? (I would love a pre-made one but at $250 USD it would cost me about $430 Canadian with exchange, fees, taxes.)
Thanks
Many of us have done this using a copper pipe cap imbedded in a jig… should be many posts and sample code here on the forum…
SG
I searched, looked through 4 pages, not much there.
See if this search has what you are looking for…
http://www.talkshopbot.com/forum/sea...earchid=237745
SG
Here's one that I found along with a rountine
X_Y Zeroing Fixture.zip
XYZ_zero.orginal.sbp
can't find the original post on SB forum for this one:
https://www.etsy.com/transaction/1013709486?
It was only $30 + shipping, you might try contacting him thru Etsy and see if he still sells them.
Daniel E.
ShopBot PRS 48x96 (2010 Model)
Porter Cable Router
Vacuum Table w/ 2 Fein vacs
Aspire 9.0
What I do when I don't mess up wood: http://www.pathhome.net
Here is a dxf of the one I did. it is .75 thick clear acrylic and has a pocket for a .75 copper pipe cap
RB…
Sorry about the bad link… apparently I’m having issues cutting and pasting with windows 10… The search was for "super z" Leave the quotes!
SG
My version is in this thread - http://www.talkshopbot.com/forum/sho...-Zero-able-Jig!
The answers to a lot of questions can be found at http://www.shopbottools.com/ShopBotDocs/ or http://support.vectric.com/