Sorry in advance for a HUGE image.

Ok, so I found that the specific ground on all the proxies and the EStop was intermittent. Pulled it from the board reseated every thing and it seems all good. But not So much.

I also tried with a power supply that was much more calibrated 4.96VDC and 12.21VDC. Same results.

Limits are On for the first 4 settings screens and off for the remainder.

I made sure that I shut down the settings windows between changes. I even rebooted twice, shut down and powered off the control box once. I don't understand why the switches appear the same when they are correctly set for Nm Open and incorrectly for Nm Closed...

My Z uses a prox on position 5. (For upper extent)

weirdness.