Thanks Brady…
I’m only making five of these… It’s a technique I’ve used for years and then suddenly I’m bit on the butt with this one! I thought it strange that I was missing steps so I’d start it over with slightly different settings… I demonstrated the definition of insanity by repeatedly trying the same thing expecting different results!
Likely the good folks at Vectric were trying to save some cutting time by not finishing the cuts of areas they thought wouldn’t be there if/when used as designed!
It used to work, something changed with a version/update and I missed the white paper…
Thanks again for verifying that I hadn’t messed up a setting somewhere!
To the Folks at Vectric… toolpathing the removal of the waste is great for rendering purposes, but in real life, time is saved by not actually running that toolpath when piercing the material!
SG