Brady
Thanks, So for the box top, which I believe would be considered a positive 3d shape, I am asking the 2 rail sweep to machine down from tip to ridge at an angle on both sides, in order to make the shape. Shape height is .3937, and model has been placed at the top of material block. no problems there.
Next, I am asking the software to machine down to that same .3937 depth with a pocket labeled "Outside of ridge"
This is where, when previewed, the depth of the outside of ridge is deeper than the depth of the "3d model, even though I have asked to machine to the very same depth. Why the inconsistency with depths, when I am entering the same value for both?
Long story short, I want the depth of the pointed 3d shape to match the depth of the out side ridge, and they are different, but need to be the same. Thanks