In reviewing the documentation supporting the installing a Spindle Control Board for a Yaskawa VFD there is a reference to using the [TR] command within an SB3 file. For example "TR, 12000,1" would command the VFD to drive the spindle a 12000 rpm. My question for those folks who may have this board installed is what happens if you send the command "TR, 0000,1" ? Does this result in the spindle dropping to zero RPMs or does one have to press th front panel Run/Stop buttons on the VFD to fully stop the spindle??

Oh, by the way I'm asking this as it would relate to a Standard version Buddy or PRS.
Mike