Is there a way of changing the starting point on a rough cut? I have a rough cutting toolpath that starts at 23,0 and moves along the Y axis. I want to be able to start at 0,0 and move along the Y axis.
Thanks
Is there a way of changing the starting point on a rough cut? I have a rough cutting toolpath that starts at 23,0 and moves along the Y axis. I want to be able to start at 0,0 and move along the Y axis.
Thanks
Yes, it is in material setup in your toolpath tab2016-01-06_1426.jpg2016-01-06_1426_001.jpg
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
Hi Kyle,
I might not have explained myself correctly. I want the rough cut to go from left to right along the x axis not right to left. I tried changing the datum point but that didn't work either.
Angelo
Hi Tim,
The entire cutting file. It rasters along the x axis. It starts on the far end of the x axis and works toward 0. I would like it to start from 0 and raster along the x axis toward the far end.
Thanks
Angelo
without seeing what your tool paths look like its hard to guide you - can you post any of it?
Tim Lucas Custom Woodworks
www.TLCW.us