I did afew upgrades to my ShopBot PRS alpha 60/120 with tool changer about 2 years ago. We did mostly signs but now we are doing a lot of plywood cutting. My dustcollector is not sucking up the dust from the new dust skirt. I am trying to figureout what the problem is. Is it the new dust skirt, do I need to run a largerpipe, or a straight pipe. I have 4” flex pipe right now running about 20’ to a 2 hp gizzly . Note that it did work ok before with that old dust skirt but there was a problem with getting it to open and close you can see the old dust skirt in action by going to the link below.
https://www.youtube.com/watch?v=KxqoEHQAiwY
Here are a few photo of the new dust skirt they installed
Looking for any help at this time.
Thank you