WTB - 2 data ribbon cables the run between VEXTA motor driver and ShopBot board
Been without a CNC machine for a couple of years now. Building a new table of my own design and trying to get back in the game.
Trying to resurrect my old Alpha controller that was, years ago, blasted by lightning. I have the board back in an operational state. I scrounged several Vexta drivers (ASO30-A-B) and motors from various sources but need two additional data cables to to complete the control system. Either that or just the plug that Vexta driver required. If I could source the d connector, I could build my own cable, but haven't found a source as yet. The plug shroud is Molex but the d connector is unknown. Anybody have a couple of cables they might want to sell? Thanks....
Reply With Quote
