Thanks, guys. It looks like I have a little experimentation to do and maybe some shopping while I'm at it!
Thanks, guys. It looks like I have a little experimentation to do and maybe some shopping while I'm at it!
-Tom
Thanks Steve, I ramp almost everything so forgot to mention.
Tom, Maybe mess around with some small test pieces with the 61-040 doing everything.
I got some good experience with that bit testing stuff when it was the only 1/8" I had.
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Scott
Nice detail About how big are the blocks and the Tatum plaque
thanks
bob
Thanks Bob,
Tatum was 4.5X9" and Freestyle Script which looks better pocketed than VCarved.
That was a text test for kid's blocks so would have been 1.75" with a 3/16" R pointed roundover for simulation.
Both in Hard Maple.
Tatum feeds/speeds are closer to what I wound up using on the first test piece.
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
The 1/4" down spiral with a final pass seemed to really help.
Now onto my next issue... learning to finish!
-Tom