3D retaill therapy:)

[scottp55]

Hope any of this helps Bob.
OH, as many of Vectric's formats as you want, but only one .stl. .obj etc per job with VCP8.

[scottp55]

Back on the booths display panel.
Got busy on other stuff, Middle one is cutting now...TREE only in a pocket like Rick's Preview.
Hoping incorporating that know will look ok
Same bit 2,2,18K 40% stepover(but I lied about the flat, so more like 20% stepover if I was actually using a .005" flat)

[scottp55]

I have the dust foot on after I took that pic of it cutting........
Halfway through I could see the trunk........WHAT THE....?

That's what I get for rushing.
Preview from ALL angles!!
Ya ever feel like a fool?
I'll cut it again, deeper and correctly....unless I say it was a cookie mold

[scottp55]

Ever have "One of those Days" ?
Fixed that wrong combine mode on laptop....TOTALLY forgetting I had rezeroed my X,Y axis on the control computer to try to get that knot in the trunk of the tree.
Youch
Resized the darn thing and quadruple checked everything, and had .05" CEL left on the bit...up till 12:39 this morning babysitting(but I LIKE it
Shame the knot went from tight to punky, whereas the other side of the board, it's only interesting grain.
Glad that board is done...almost cut it into 3 pieces after looking at that perimeter pass, but then remembered I don't have a woodstove
scott

[scottp55]

This one's cutting right now.
Checked it maybe 10 times, and still worried like a Newbie before I pressed Start
Last 3D until this 3 day weekend's show is over.

[Tom-3344]

This one's cutting right now.
Checked it maybe 10 times, and still worried like a Newbie before I pressed Start
Last 3D until this 3 day weekend's show is over.

After all the suspense, I am going to have to go to the show to see how it all turned out.

Tom

[scottp55]

Only 33% done, but on this one even I'm amazed at the detail the dustfoot is teasing me with!
It's a wholesale only show, but I'm keeping the "Old Man", and this "Old Town" one for myself (and 2 Quilted Maple)!!
You're welcome to drop by the house and watch the Desktop in person, just e-mail me under my contact info.
scott

[scottp55]

Feels like Christmas when one of your packages has a rip in the wrapping and you can see a Little...
You have to judge size by the dustfoot bristles.

[scottp55]

Straight off the machine, no sanding.

[scottp55]

A few more. 1 coat 50/50 Polymerized Linseed/Citrus thinner.
No sanding.