Hello.
I have been using CPP fairly successfully for the past 5 years and think it's wonderful when it works properly. Last year my lap top crashed and I needed to buy a new one so I asked if I could transfer the CPP software to the new lap top. I was told the they did not support that outdated version and that I would have to buy the updated version. That was ok, but the new version does not give me good cut files. The X-axis and Y-axis are reverse. The settings are all correct (x=48" and y=96") and the nesting is correct (nest with grain lengthwise) but the cut files are reversed. I have tried contacting Ryan with little success. I was wondering if there is anybody in this form that could help me or advise me on who to turn to.
Any help would be appreciated,
Al
SOS Cabinets